Date post: | 12-Apr-2017 |
Category: |
Engineering |
Upload: | corydon-coppola-cpesc |
View: | 109 times |
Download: | 0 times |
Corydon Coppola, CPESCPresident
www.flo-water.net
Standard Dewatering Bag
The flow rate for the standard dewatering bag is 95 gal/min/ft2 versus 192 gal/min/ft2 for the Pump-It Tube.
Pump-It Tube enables solutions at higher flow rates. Increasing productivity .
The standard dewatering bags ranging from 3x3, 6x6, 10x15, to 15x15.
Pump-It Tube vs. Standard BagA 15ft x 15ft dewatering bag is replaced by a 40 inch x 20
ft Pump-It Tube.
Pump-It Tubes- Straps with D-Rings attach aroundtubes from pumps
Curb Inlet Protection (Clip Guard)
The Clip Guard is ideal for protecting concrete storm drains from silt and debris.• Installs easily, just clip into place• High Flow Grey Material allows 192 gal/ft2/min• Reusable-After use; clean by spraying out sediment• Also available in custom sizes• Hydrocarbon model- incorporate polymor which solidifies hydrocarbons. • Reusable
Overflow protection available on above grate models- as well.
EZ Inlet Guard Flat Grate
EZ Inlet GuardCurb Style
Custom Sizes available for any inlet protection
HiFlo/ MaxxFlo Silt Fence
HiFlo Silt fence® & MaxxFlo Silt Fence are patent pendingHiFlo & MaxxFlo Silt Fence allows better flow than standard silt fence.• Allows better flow while keeping silt on the site• HiFlo Grey Material allows up to 192 gal/ft2/min• MaxxFlo Silt Fence material allows for significantly higher flow rates.• Built in scrim for added strength• Wood stake rolls in 50’ & 100’ lengths- Custom stake spacing and sizing • 500’ rolls with no stakes
Hi Flows filter up to @ 192 gal/ft2/min
Capture sediment for safe disposal
Better Curb Appeal
Traffic Friendly
Reusable
Out with the half solutions, and in with the increased protection
Drivable solutions- not reducing accessibility
Above Grate Inlet Protection
Protect Drains and Inlets WITHOUT Lifting Any Grates• Keeps dirt, sand, sediment, trash and debris out of drains• Fast installation using built in magnets – no lifting of heavy catch basin grates.• Common stocked sizes for street & combo drains . Custom sizes also available.• Heavy-duty, reinforced material allows up to 192 gal/ft2/min. through drains.• EZ maintenance –remove unit, shake off dirt, silt and sediment and replace.• Low-profile design can be driven over and is unobtrusive to traffic and personnel.• EZ Inlet Guard- awarded Product Of The Year in its division by Plant Engineering.
Visually Superior Solution coupled with increased performance
Easier to clean, reusable, drivable.
Dishonorable Discharge
MSD Wash Out Pit
“EZ- Concrete Washout System”
Treat Slurry & Release on Site EZ Concrete Washout System Steps for Proper Treatment PH Levels Set Up Stand as Pictured above (Each bag/ Stand Should handle 3- 10 trucks)
The following steps are per concrete washout (Per truck) Stabilized 1. Sprinkle 5 lb bag of “EZ Washout PH Stabilizer” across bottom of Stand 2. Upon Starting Rinse Flow, 8 oz bottle of Solution #1 needs to be added at the rinse flow to ensure proper mixing
3. Add 8 oz bottle of Solution #2 in the same manner as step 3. (Solution 1, then Solution 2) *Additional mixing with a few more gallons of the rinsewater will ensure adequate mixing.*
EZ Concrete Washout System Bag/ Stand will hold up to 1 cubic yard of waste. This should handle 3- 10 trucks per use. (Dependent on amount of concrete dumped before rinsing process)